Ампери към Конски сили Калкулатор
Изчислете обратно изходната мощност на вашия двигател в конски сили въз основа на тока, който консумира от линията. Идеално за проверка на спецификациите на оборудването на място.
Одит на мощността на двигателя
Ампераж → Изходна мощност HP
Мощност на вала въз основа на електрическия вход.
Формула за преобразуване
Изходната мощност на двигателя в конски сили се изчислява от електрическия вход — ефективността и факторът на мощността определят колко енергия се превръща в механична работа.
DC двигатели
HP = (I × V × Eff) ÷ 746 Електрическата входна мощност (I × V), умножена по ефективността, дава изходни ватове, които се делят на 746, за да се получат конски сили.
Еднофазни AC двигатели
HP = (I × V × Eff × PF) ÷ 746 AC двигателите изискват фактор на мощността — само реалната мощностна част (V × I × PF) се преобразува в механичен изход.
Трифазни AC двигатели
HP = (√3 × I × V × Eff × PF) ÷ 746 Факторът √3 отчита разпределението на мощността в три фази. Трифазните двигатели доставят повече мощност на ампер от еднофазните.
How to Convert Amps to Horsepower
Converting amps to horsepower lets you determine a motor's mechanical output from its electrical input measurements. This is useful when the motor nameplate is damaged or missing, when verifying motor performance, or when comparing measured current draw to the rated HP. The key insight: not all electrical input becomes mechanical output — efficiency and power factor dictate how much is lost as heat.
Understanding Motor Efficiency
Motor efficiency is the ratio of mechanical output power to electrical input power. A 5 HP motor drawing 15A at 240V and 0.85 PF consumes about 3,060W of real input power. At 90% efficiency, it delivers 2,754W (≈ 3.69 HP) of mechanical output. The rest becomes heat in the windings. Premium-efficiency motors minimize this loss.
When to Use This Calculation
- Verifying Motor Output: Measure FLA with a clamp meter and calculate HP to confirm the motor is delivering its rated output.
- Troubleshooting Overloads: If the calculated HP is significantly below rated, the motor may be worn, undersized, or operating with a degraded power factor.
- Pump and Fan Selection: When replacing driven equipment, knowing actual HP output (not just nameplate) prevents under-sizing the new load.
- Energy Audits: Calculate actual HP output versus nameplate rating to identify inefficient motors worth replacing with premium-efficiency units.
Step-by-Step Conversion
- Measure or Find the Current: Use a clamp meter for measured FLA, or use the nameplate value.
- Note the Supply Voltage: Use line-to-line voltage for three-phase; line-to-neutral for single-phase.
- Multiply by Efficiency: Motor efficiency in decimal form (85% = 0.85).
- Multiply by Power Factor (AC): Typical induction motors run 0.80–0.92 PF at full load.
- Divide by 746: Convert watts to horsepower using the 746 W/HP constant.