Ampery na Konie Mechaniczne Kalkulator
Odwrotnie oblicz moc wyjściową silnika w koniach mechanicznych na podstawie prądu pobieranego z linii. Idealne do weryfikacji specyfikacji sprzętu w terenie.
Audyt Mocy Silnika
Natężenie → Moc Wyjściowa HP
Moc na wale na podstawie mocy elektrycznej wejściowej.
Wzór Konwersji
Moc wyjściowa silnika jest obliczana na podstawie mocy elektrycznej wejściowej — sprawność i współczynnik mocy określają, ile energii zamienia się w pracę mechaniczną.
Silniki DC
HP = (I × V × Eff) ÷ 746 Elektryczna moc wejściowa (I × V) pomnożona przez sprawność daje moc wyjściową w watach, którą dzieli się przez 746, aby uzyskać konie mechaniczne.
Silniki AC Jednofazowe
HP = (I × V × Eff × PF) ÷ 746 Silniki AC wymagają współczynnika mocy — tylko część mocy czynnej (V × I × PF) zamienia się w moc mechaniczną.
Silniki AC Trójfazowe
HP = (√3 × I × V × Eff × PF) ÷ 746 Współczynnik √3 uwzględnia rozkład mocy na trzy fazy. Silniki trójfazowe dostarczają więcej mocy na amper niż jednofazowe.
How to Convert Amps to Horsepower
Converting amps to horsepower lets you determine a motor's mechanical output from its electrical input measurements. This is useful when the motor nameplate is damaged or missing, when verifying motor performance, or when comparing measured current draw to the rated HP. The key insight: not all electrical input becomes mechanical output — efficiency and power factor dictate how much is lost as heat.
Understanding Motor Efficiency
Motor efficiency is the ratio of mechanical output power to electrical input power. A 5 HP motor drawing 15A at 240V and 0.85 PF consumes about 3,060W of real input power. At 90% efficiency, it delivers 2,754W (≈ 3.69 HP) of mechanical output. The rest becomes heat in the windings. Premium-efficiency motors minimize this loss.
When to Use This Calculation
- Verifying Motor Output: Measure FLA with a clamp meter and calculate HP to confirm the motor is delivering its rated output.
- Troubleshooting Overloads: If the calculated HP is significantly below rated, the motor may be worn, undersized, or operating with a degraded power factor.
- Pump and Fan Selection: When replacing driven equipment, knowing actual HP output (not just nameplate) prevents under-sizing the new load.
- Energy Audits: Calculate actual HP output versus nameplate rating to identify inefficient motors worth replacing with premium-efficiency units.
Step-by-Step Conversion
- Measure or Find the Current: Use a clamp meter for measured FLA, or use the nameplate value.
- Note the Supply Voltage: Use line-to-line voltage for three-phase; line-to-neutral for single-phase.
- Multiply by Efficiency: Motor efficiency in decimal form (85% = 0.85).
- Multiply by Power Factor (AC): Typical induction motors run 0.80–0.92 PF at full load.
- Divide by 746: Convert watts to horsepower using the 746 W/HP constant.